How To Light A Pilot Light On A Honeywell Furnace Guide 2022. First, you may want to turn the furnace off and disconnect the gas, giving the air time to clear in case gas has been leaking out of the pilot. If all systems are working, then you’re ready to try to light the pilot.
How To Light A Pilot Light On A Nordyne Furnace References from nutri28.conflictxdesign.org
In principle, lighting a furnace pilot light is not terribly complicated. Light your match or lighter and depress the button, knob, or lever. A number of things can make an old furnace pilot light go out, including a strong draft, a faulty thermocouple or a loss of gas.
Table of Contents
Once The Gas Has Had Time To Dissipate, Turn The Knob To Pilot.
Light your match or lighter and depress the button, knob, or lever. Press the gas control knob down all the way and hold it in the depressed position. Most furnaces have instructions attached to them.
Make Sure The Pilot Light Is Out.
If you have no igniter, move the match or barbecue lighter flame to the end of the pilot tube; A modern gas furnace usually has an electronic spark generator to ignite the gas when the thermostat calls for heat. It is highly recommended to turn to your furnace’s owner’s manual and.
Push Down The Red Button To The Left Of The Gas Knob.
Turn the furnace back on. A number of things can make an old furnace pilot light go out, including a strong draft, a faulty thermocouple or a loss of gas. In principle, lighting a furnace pilot light is not terribly complicated.
The Pilot Flame Should Light Immediately.
An older gas furnace has a standing pilot that stays on all the time — or at least, it's supposed to. If your pilot light goes out, all you need to. Hold the pilot button down for about 20 seconds to give the thermocouple time to heat up, then release it.
Hold The Red Button Down While Pressing The Piezo Ignitor Striker, Found To The Immediate Right Of The Gas Knob, Repeatedly Until The Pilot Is Lit.
If the furnace has an electronic ignition, turn off the power by turning off the circuit breaker that controls the furnace. This will reduce the risk of explosion, fire or electrical shock while you light the pilot and start the furnace. Then, turn down the thermostat to its lowest setting.
Skip to content
