How To Light A Pilot Light On A Water Heater Whirlpool 2021 Guide 2022. Press control button and light. You may need to hold the knob in for up to a minute before the pilot light stays lit.
How To Turn On Water Heater Ao Smith 2021 How to Guide 2022 from paseo7.anticop21.org
Press and hold the control knob to let the gas flow into the pilot light. Push the on/off/pilot knob down with one hand and use your other to hold a barbecue lighter. To relight the pilot, turn the oven control knob to the “off” position and remove the oven’s broiler carriage.turn off the gas and ventilate the kitchen, then turn the gas back on and relight the pilot.turn the breaker to the off position.
Table of Contents
Locate The Pilot Light On Your Wall Heater.
Place this fire source under the orifice of the pilot supply line to ignite the. Press and hold the control knob to let the gas flow into the pilot light. Your gas water heater’s pilot light may have gone out.
You May Need To Hold The Knob In For Up To A Minute Before The Pilot Light Stays Lit.
* professional service * fast response time * pilot light lighting & relighting * pilot light troubleshooting * pilot light repair & maintenance * fireplaces, stoves, water heaters. Pilot light relighting in michigan. Search for the owner’s manual for your water heater.
This Indicates That The Pilot Of The Water Heater Is Lit.
Right after a second, press the ignition button till the status light begins to blink every few seconds. Lighting a water heater pilot light at a glance. Dial or rotate the gas control knob to the pilot position.
Use Either A Lighter, Match Or Candle To Provide The Flame Required To Relight The Pilot Light.
This whole process will take approximately 1 minute for a newly installed unit. It is usually a small metal knob near the bottom of the heater. Our contractors can take care of all your pilot light needs.
To Relight The Pilot, Turn The Oven Control Knob To The “Off” Position And Remove The Oven’s Broiler Carriage.turn Off The Gas And Ventilate The Kitchen, Then Turn The Gas Back On And Relight The Pilot.turn The Breaker To The Off Position.
If there are more inner plates, move them as well until you see the actual pipes. Turn controls to “pilot mode”. Press control button and light.
Skip to content
